The sprocket/pulley nut just torques to 50 ft/lbs on the initial setting to begin with. After that its a visual degree setting of 30 to 40 degrees past 50 ft/lbs. Just how much torque do you think you end up putting on it anyway? Its not that much, that's the reason for the timed locking plate that goes around the nut when it spec'd out.
The torque spec on this nut is 210ft.lbs, Chris The changed the torque with TT 211. TT 211 - September 16, 2005 Sportster and Buell XB Model Flywheel Sprocket Shaft Nut Torque Update The flywheel sprocket shaft nut torque for 2004 & later Sportsters and 2003 & later Buell XB models has been changed.
Jun 08, 2018 · Turns out the new sprocket is roughly 1mm thinner in the clamping area. That means the stock nuts are engaging threads that were previously unthreaded. Comparison of stock sprocket bolt threads to sprocketcenter, Superlite sprocket bolt threads. No visible damage from over-torquing the bolts. I'll check on the nuts in a little bit.
Tighten the axle nut to spec using a torque wrench and insert the cotter key (where applicable). Torque the drive sprocket nut to spec (rear wheel on the ground) and bend the tabs against the flats of the nut. Reinstall the transmission covers.
Harley Davidson tool Sprocket shaft pulley nut or sprocket removal tool used to change drive belt pulley or chain sprocket too 1 7/8 inch nut . works on Shov...
Nissan Frontier, Xterra 1998-05 Torque Specifications Repair Guide. ... Audi A4 and Sedans 1999-05 Transmission Control Module Repair Guide.
Baixar musica do preto show ta baixar